This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
ycsserver:dr1x:dr1x_configuration [2021/10/05 10:37] dg9ffm [Wiring of the connection cable] |
ycsserver:dr1x:dr1x_configuration [2021/10/05 11:48] (current) dg9ffm [Recommended configuration of the DR-1X repeater] |
||
---|---|---|---|
Line 3: | Line 3: | ||
Unfortunately, | Unfortunately, | ||
\\ | \\ | ||
- | However, the DR1-X with its [Control I/O] connector offers the option of using an external repeater control, for example an MMDVM modem.\\ | + | However, the DR1-X with its [Control I/O] connector offers the option of using an external repeater control, for example an MMDVM modem. |
- | This expansion can be carried out without interfering with the repeater hardware and turns the dr1-x into a full-fledged mmdvm repeater, which now also supports DG-ID (System Fusion II) and can be connected directly to a YCS server.\\ | + | This expansion can be carried out without interfering with the repeater hardware and turns the DR1-X into a full-fledged mmdvm repeater, which now also supports DG-ID (System Fusion II) and can be connected directly to a YCS server.\\ |
\\ | \\ | ||
\\ | \\ | ||
Line 48: | Line 48: | ||
| 15 | Switched VCC (13.8 V) | | | | | | 15 | Switched VCC (13.8 V) | | | | | ||
\\ | \\ | ||
+ | \\ | ||
+ | ==== Configuration of DR1-X ==== | ||
+ | |||
+ | * Set **"UP LINK" | ||
+ | * Set **" | ||
+ | * Set **" | ||
+ | \\ | ||
+ | Further useful information for the configuration of the DR1-X and instructions for level adjustment of the MMDVM board with the help of pistar can be found in the following document: | ||
+ | |||
+ | * RB_DR-1x setup.pdf | ||
+ | * [[http:// | ||
+ | \\ | ||