This is an old revision of the document!
After the basic configuration of the DR-2X repeater (uplink and downlink frequencies, transmission power, Callsign and more …) it can now be connected to a ycs server. The following article describes a recommended configuration for the connection.
Use a micro-USB cable to connect the DR-2X repeater to a PC that has the IMRS setup software installed. Then start the IMRS setup software.
The next step is to configure the repeater's own DG-ID (01) and the desired DG-ID's to be connected to the YCS server.
In the next step, the DG-IDs are configured which should be connected to the ycs server. It is possible to configure all DG-ID (02-99).
(Please note that only configured DG-IDs can be used. This also applies to the RF side.)
In this step, the timers for the transmission time limit (TX TOT) and DG-ID hold time (IMRS TOT) are configured.