This is an old revision of the document!
After the basic configuration of the DR-2X repeater (uplink and downlink frequencies, transmission power, Callsign and more …) it can now be connected to a ycs server. The following article describes a recommended configuration for the connection.
Use a micro-USB cable to connect the DR-2X repeater to a PC that has the IMRS setup software installed. Then start the IMRS setup software.
The next step is to configure the repeater's own DG-ID (01) and the desired DG-ID's to be connected to the YCS server.
In the next step, the DG-IDs are configured which should be connected to the ycs server. It is possible to configure all DG-ID (02-99).
(Please note that only configured DG-IDs can be used. This also applies to the RF side.)
In this step, the timers for the transmission time limit (TX TOT) and DG-ID hold time (IMRS TOT) are configured.
After the DR-2X has now been successfully connected to the YCS, it will now appear on the dashboard.
Please contact the YCS server sysop so that he can enter any missing information about the new repeater.
You can find the contact email on the dashboard of the YCS (SITE-INFO).
The following information is required: