This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
ycsserver:dr2x:dr2x_configuration [2021/03/02 00:10] dg9ffm [Recommended configuration of the DR-2X repeater] |
ycsserver:dr2x:dr2x_configuration [2022/05/29 08:19] (current) dg9ffm [Network configuration of the DR-2X] |
||
---|---|---|---|
Line 17: | Line 17: | ||
* Use "Write to Device..." | * Use "Write to Device..." | ||
- | * //The IMRS communicates with the LAN-01A via specified port 21110 (default). DO NOT CHANGE the “21110” UDP port setting. Also you should set the router firewall to open the UDP port “21110”.When using a router to connect the PC to the Internet, the UDP port must go through the router as well; however, communications using this port is generally prohibited on commercially available routers in the default setting.Therefore, | + | * //The IMRS communicates with the LAN-01A via specified port 21110 (default). DO NOT CHANGE the “21110” UDP port setting. Also you should set the router firewall to open the UDP port “21110”.When using a router to connect the PC to the Internet, the UDP port must go through the router as well; however, communications using this port is generally prohibited on commercially available routers in the default setting.Therefore, |
* On “Destination Repeater' | * On “Destination Repeater' | ||
Line 24: | Line 24: | ||
* Enter the IP address of the desired YCS server | * Enter the IP address of the desired YCS server | ||
+ | * //for example:// | ||
+ | * //using Internet: **185.228.139.209** = YCS262 (DE C4FM Germany)// | ||
+ | * //using Hamnet: **44.148.237.4** = YCS262 (DE C4FM Germany)// | ||
+ | |||
+ | |||
* Use "Write to Device..." | * Use "Write to Device..." | ||
Line 29: | Line 34: | ||
==== DG-ID configuration of the DR-2X ==== | ==== DG-ID configuration of the DR-2X ==== | ||
+ | // => Please follow the instructions carefully so that correct operation is possible with the correct configuration.// | ||
+ | \\ | ||
The next step is to configure the repeater' | The next step is to configure the repeater' | ||